Service kaart.
Binnenkort ook hier te vinden om je settinglijst in je pioneer te zetten zonder j-tag .
Dit staat hier a.s. zondag om dit board.
Spirit_rules
aja??dat zou prachtig zijn.
ALVAST EEN KLEINE TOELICHTING IN HET ENGELS:
Software for PicCard and FunCard for moving flash sections between PC and tuner without programming throught COM+LPT cables or Jtag device.
‘PicCard.hex’ - for PicCard with PIC16[C/F]84(A)
‘FunCard.hex’ - for FunCard with AT90S8515(A)
Required eeprom memory on card is 24C512 (64KB i2c eeprom, with other memories it won’t work properly).
The writing and reading protocol was designed in that way that the bytes are written and read from eeprom during communication, so there is no additional time reserved for writing or reading besides the time needed to transmit or receive bytes from card. Using of 128-byte packages (maximal allowed by 24C512) decreases the writing/reading cycles of the specified section which also shorts the writing and reading process.
The entire eeprom space is used for writing and there isn’t any special data in it for the card to work. All you have to do is to replace memory with 24C512 (doesn’t concern FunCard5 which already has 24C512) and program processor’s flash and the card is ready to work.
NOG FF WACHTEN…\
HOU ALVAST MAAR EEN LEGE FUN-KAART GEREED
ZONDAG OM 22.00 uur
Spirit_rules
Lijkt me heel interessant, maar… waarom zondag pas. 
Groeten Harry
beetje spannend te houden…
nee, maar ik ben bezig om een nieuwe firmware te vertalen en dit hoort erbij…